Specifications

Entering Commands
3-7
3
To enter the other modes, at the configuration prompt type one of the following
commands. Use the exit or end command to return to the Privileged Exec mode.
For example, you can use the following commands to enter interface configuration
mode, and then return to Privileged Exec mode
Command Line Processing
Commands are not case sensitive. You can abbreviate commands and parameters
as long as they contain enough letters to differentiate them from any other currently
available commands or parameters. You can use the Tab key to complete partial
commands, or enter a partial command followed by the “?” character to display a list
of possible matches. You can also use the following editing keystrokes for
command-line processing:
Table 3-12 Configuration Commands
Mode Command Prompt Page
Line line {console | vty} Console(config-line)# 3-9
Access
Control List
access-list ip standard
access-list ip extended
access-list ip mask-precedence
access-list mac
access-list mac mask-precedence
Console(config-std-acl)
Console(config-ext-acl)
Console(config-ip-mask-acl)
Console(config-mac-acl)
Console(config-mac-mask-acl)
3-66
Interface interface {ethernet port | port-channel id| vlan id} Console(config-if)# 3-99
VLAN vlan database Console(config-vlan) 3-131
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#
Table 3-13 Keystroke Commands
Keystroke Function
Ctrl-A Shifts cursor to start of command line.
Ctrl-B Shifts cursor to the left one character.
Ctrl-C Terminates the current task and displays the command prompt.
Ctrl-E Shifts cursor to end of command line.
Ctrl-F Shifts cursor to the right one character.
Ctrl-K Deletes all characters from the cursor to the end of the line.
Ctrl-L Repeats current command line on a new line.
Ctrl-P Enters the last command.
Ctrl-R Repeats current command line on a new line.
Ctrl-U Deletes from the cursor to the beginning of the line.
Ctrl-W Deletes the last word typed.