Specifications

Interface Commands
3-99
3
Interface Commands
These commands are used to display or set communication parameters for an
Ethernet port, aggregated link, or VLAN.
interface
Use this command to configure an interface type and enter interface configuration
mode. Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
• vlan vlan-id (Range: 1-4094)
Default Setting
None
Table 3-41 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface configuration
mode
GC 3-99
description Adds a description to an interface configuration IC 3-100
speed-duplex Configures the speed and duplex operation of a given interface
when autonegotiation is disabled
IC 3-100
negotiation Enables autonegotiation of a given interface IC 3-101
capabilities Advertises the capabilities of a given interface for use in
autonegotiation
IC 3-102
flowcontrol Enables flow control on a given interface IC 3-103
shutdown Disables an interface IC 3-104
switchport broadcast
packet-rate
Configures broadcast storm control IC 3-104
clear counters Clears the statistics on a given interface PE 3-105
show interfaces status Displays status for the specified interface NE, PE 3-106
show interfaces
counters
Displays statistics for the specified interfaces NE, PE 3-107
show interfaces
switchport
Displays the administrative and operational status of an interface NE, PE 3-108