Specifications

Interface Commands
3-109
3
Example
This example shows the configuration setting for port 25.
Console#show interfaces switchport ethernet 1/22
Information of Eth 1/22
Broadcast threshold: Enabled, 500 packets/second
Lacp status: Disabled
Ingress rate limit: disable,100M bits per second
Egress rate limit: disable,100M bits per second
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Disabled
Allowed Vlan: 1(u),
Forbidden Vlan:
Console#
Field Description
Broadcast threshold Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (See page 3-104.)
Lacp status Shows if Link Aggregation Control Protocol has been enabled or disabled (See
page 3-114.)
VLAN membership mode Indicates membership mode as Trunk or Hybrid (See page 3-134.)
Ingress rule Shows if ingress filtering is enabled or disabled (See page 3-135.)
Acceptable frame type Shows if acceptable VLAN frames include all types or tagged frames only (See
page 3-134.)
Native VLAN Indicates the default Port VLAN ID (See page 3-136.)
Priority for untagged traffic Indicates the default priority for untagged frames (See page 3-144.)
Gvrp status Shows if GARP VLAN Registration Protocol is enabled or disabled (See page
3-141.)
Allowed Vlan Shows the VLANs this interface has joined, where “(u)” indicates untagged and
“(t)” indicates tagged (See page 3-137.)
Forbidden Vlan Shows the VLANs this interface can not dynamically join via GVRP (See page
3-138.)