Specifications

Configuring SNMP
2-23
2
• The default setting is null, which allows all IP groups SNMP access to the switch.
If one or more IP addresses are configured, IP filtering is enabled and only
addresses listed in this table will have SNMP access.
Command Attributes
• IP Filter List – Displays a list of the IP address/subnet mask entries currently
configured for SNMP access.
• IP address – Specifies a new IP address to add to the IP Filter List.
• Subnet Mask – Specifies a single IP address or group of addresses. If the IP is the
address of a single management station, set the mask to 255.255.255.255.
Otherwise, an IP address group will be specified by any other mask.
Web – Click SNMP, SNMP IP Filtering. To add a client, enter the new address, the
subnet mask for a node or an address range, and then click “Add IP Filtering Entry.”
Figure 2-17 Filtering Addresses for SNMP Access
CLI – This example allows SNMP access for a specific client.
Console(config)#snmp ip filter 10.1.2.3 255.255.255.255 3-97
Console(config)#