Specifications

Command Groups
A-106
Interface Commands
ThecommandsdescribedinTable A‐15areusedtoconfigureconnectionparametersforthe
Ethernetportandwirelessinterface.
Table A-15 Interface Commands (Ethernet and Wireless)
Command Function Mode Page
General Interface
interface Enters specified interface configuration
mode
GC A-109
Ethernet Interface
cdp authentication Specifies an authentication key for CDP
packets
IC-E A-110
cdp auto-enable Set CDP in auto-enable mode GC A-111
cdp disable Set CDP in disable mode GC A-112
cdp enable Set CDP in enable mode GC A-113
cdp hold-time Sets amount of time that AP holds
neighbor entry
GC A-114
cdp tx-frequency Set CDP transmit frequency GC A-115
show cdp Displays CDP global settings, neighbor
entries, traffic statistics or port.
Exec A-116
dns Specifies the primary or secondary name
server
IC-E A-118
ip address Sets the IP address for the Ethernet
interface
IC-E A-119
ip dhcp Submits a DHCP request for an IP
address
IC-E A-121
shutdown Disables the Ethernet interface IC-E A-122
show interface
ethernet
Shows the status for the Ethernet
interface
Exec A-123
Wireless Interface
description Adds a description to the wireless
interface
IC-W
IC-W: VAP
A-124
secure-access When enabled, the Access Point denies
access to wireless clients that do not use
the correct wireless network name.
IC-W
IC-W: VAP
A-125
speed Configures the maximum data rate at
which a station can connect to the
access point
IC-W A-126
channel Configures the radio channel IC-W A-127
turbo Configures turbo mode to use a faster
data rate
IC-W A-128