Specifications

Command Groups
RoamAbout Access Point 3000 Configuration Guide A-129
ssid
Thiscommandconfigurestheservicesetidentifier(SSID).
Syntax
ssid string
stringisthenameofabasicservicesetsupportedbytheaccesspoint.Range:1‐32characters
Default Setting
RoamAboutDefaultNetworkName
Command Mode
InterfaceConfiguration(Wireless)
InterfaceConfiguration(Wireless):VAP
Command Usage
•UsethiscommandforthedefaultinterfaceoranyofthesevenVAPsconfigurableperradio
interface.
•ClientsthatwanttoconnecttothewirelessnetworkviaanaccesspointmustsettheirSSIDs
tothesameasthatoftheaccesspoint.
Example
ThefollowingexampleshowssettingtheservicesetidentifierforthedefaultinterfaceandaVAP.
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface wireless g
RoamAbout 3000(if-wireless g)#ssid RD-AP#3-G
RoamAbout 3000(if-wireless g)#vap 3
RoamAbout 3000(if-wireless g: VAP[3])#ssid RD-AP#3-GV3
RoamAbout 3000(if-wireless g: VAP[3})#end
RoamAbout 3000(if-wireless g)#