Specifications

Administration
RoamAbout Access Point 3000 Configuration Guide 4-41
Using the CLI
TodownloadsoftwarefromaTFTP/FTPServer,usethecopycommandfromtheExecmode.The
copycommandrequiresyoutospecifyeitherthefiletypeandthentheservertype,ortheserver
typeandthenthefiletype.Youmustthenspecifythefilename,andIPaddressof
theTFTP
server.Whenthedownloadiscomplete,youcanusethedircommandtocheckthatthenewfileis
presentintheaccesspointfilesystem.Torunthenewsoftware,usetheresetboardcommandto
reboottheaccesspoint.
RoamAbout 3000#
RoamAbout 3000#copy tftp file
1. Application image
2. Config file
3. Boot block image
Select the type of download<1,2,3>: [1]:1
TFTP Source file name:ets-img_v2.1.2.bin
TFTP Server IP:196.192.18.1
FTP Username:[admin]:
FTP Password:[password]:
RoamAbout 3000#copy ftp file
1. Application image
2. Config file
3. Boot block image
Select the type of download<1,2,3>: [1]:2
FTP Source file name:ets_310.cfg
FTP Server IP:10.2.20.140
FTP Username:[admin]:
FTP Password:[password]:
The configuration file was properly copied over to the system but a later
setup command will override the file. A reset is needed in order for the
configuration file changes to take place.
RoamAbout 3000#reset board
Reboot system now? <y/n>: y