Installation guide

Hardware Description
1-7
Reset Button
This button is used to reset the access point or restore the factory default configuration. If
you hold down the button for less than 5 seconds, the access point will perform a
hardware reset. If you hold down the button for 5 seconds or more, any configuration
changes you may have made are removed, and the factory default configuration is
restored to the access point.
Power Connector
The access point does not have a power switch. It is powered on when connected to the
AC power adapter, and the power adapter is connected to a power source. The power
adapter automatically adjusts to any voltage between 100~240 volts at 50 or 60 Hz. No
voltage range settings are required.
The access point may also receive Power over Ethernet (PoE) from a switch or other
network device that supplies power over the network cable based on the IEEE 802.3af
standard.
Note: The access point supports both endspan and midspan PoE.
If the access point is connected to a PoE source device and also connected to a
local power source through the AC power adapter, AC power will be disabled.