Installation guide

Wireless Switch Configuration Tasks
RBT-8100 Wireless Switch Installation Guide 3-7
6. EnabletheMSSDNS client:
RBT-8100# set ip dns server enable
7. Enabletheauto‐configoption:
RBT-8100# set auto-config enable
8. Createaself‐signedadministrativecertificate,toenableRASMorWebViewtocommunicate
withtheRoamAboutwirelessswitch.(SeeStep 4inExample1:DeploymentSiteHasDHCP
andLocalDNSonpage 3‐5.)
9. Savetheconfigurationchanges:
RBT-8100# save config
10. Powerofforrestarttheswitch.
Example 4: Deployment Site Has DHCP But Local DNS Domain Differs From
Corporate DNS Domain
ThedeploymentsiteinthisexamplehasaDHCPserver,sotheswitch’sDHCPclientisenabled.
StaticIPaddressanddefaultgatewayinformationarenotrequired.ThesitealsohasalocalDNS
server.However,thelocalDNSdomainnameisdifferentfromthecorporateDNSdomainname
wherethe
RASMserverislocated.ThestaticDNSconfigurationontheswitchoverridestheDNS
configurationfromtheDHCPserver.
1. ConfigureaVLAN:
RBT-8100# set vlan 1 port 1
2. EnabletheDHCPclientonVLAN 1:
RBT-8100# set interface 1 ip dhcp-client enable
3. ConfigurethedefaultDNSdomainname:
RBT-8100# set ip dns domain customer.com
4. ConfigureDNSserverinformation:
RBT-8100# set ip dns server 192.168.11.2
5. EnabletheMSSDNS client:
RBT-8100# set ip dns server enable
6. Enabletheauto‐configoption:
RBT-8100# set auto-config enable
7. Createaself‐signedadministrativecertificate,toenableRASMorWebViewtocommunicate
withtheRoamAboutwirelessswitch.(SeeStep 4inExample1:DeploymentSiteHasDHCP
andLocalDNSonpage 3‐5.)
8. Savetheconfigurationchanges:
RBT-8100# save config
9. Powerofforrestarttheswitch.