Installation guide

SNS-TAG-HPA / SNS-TAG-LPA Installation Guide 4-1
4
Upgrading Trusted Access Gateway Software
ThischapterdescribestheproceduretoupgradetheTrustedAccessGatewaysoftwareontheTAG
appliance.YouwillneedtoconnectamonitorandaUSBkeyboardtotheTAGappliancepriorto
performingthesesteps.
1. GototheEnterasysNetworkswebsitetodownloadtheTAG.zipfiletoyoursystem:
http://www.enterasys.com/products/management/downloads
2. ExtracttheTAG.zipfiletoadirectoryonyoursystem.
3. InserttheUSBflashdrivethatcamewiththeTAGapplianceintotheUSBportonyoursystem
andnotethedriveletteritisassigned.
4. OpenacommandpromptwindowandcdtothedirectorywhereyouextractedtheTAG.zip
file.
5. Typemake_disk.bat <drive letter>:andpressEnter.
ThefileswillbecopiedtotheUSBflashdrive.Whenthecopyiscompleteyouwillseethe
message“Successfullyinstalledinto<driveletter>:Pressanykeytocontinue.”
6. RemovetheUSBflashdrivefromyoursystem.
7. InserttheUSBflashdriveintoeitherUSBport(see
Figure 1‐1)ontheTAGappliance.
8. Pressthepowerbutton,andthenpressF2togototheBIOSsetup.
9. UsethearrowkeystonavigatetoBOOToption.
10. EnsurethattheUSBflashdriveislistedasPriority1.Ifitisnot,moveittoPriority1.
11. PressSaveto
exit.
12. TheappliancestartsbootingfromtheUSBflashdrive.
13. Whenthebootiscomplete,theApplianceInstallationscreenappears.
Selecttheappliancetype,andpressEnter.Theinstallationbegins.
14. Aftertheinstallationcompletes,reboottheapplianceandthenremovetheUSBflashdrive.
15. ProceedtoChapter 3,ConfiguretheAppliance,andfollow
theinstructionsforconfiguring the
TAGappliance.
16. IfyouareupgradingyourTrustedAccessGatewaysoftware,besuretoenforcetheTAG
appliance(usingTrustedAccessManager)followingtheupgradeoperation.Enforcingwrites
yourTrustedAccessManagerSecurityDomaininformationtotheappliance.