User's Manual

CHAPTER 8 INTERFACE CONTROL DOCUMENTS (ICD)
APPENDIX A INTERFACE CONTROL DOCUMENTS (ICD)
ISSUE/REVISION DATE: 25 JULY 2007 TECHNICAL MANUAL
ISO 9001:2000 PROPRIETARY
Interface Control Document (ICD) ENTERPRISE ELECTRONICS CORPORATION
Rev No. 5 Page 17 of 21
Issue Date 25 July 2007 UM-130365
Distribution Data Collection
Module (DDC)
THE DATA PRESENTED HEREIN REPRESENTS THE INTELLECTUAL PROPERTY OF ENTERPRISE ELECTRONICS CORPORATION (EEC). THIS DATA MAY NOT BE DISTRIBUTED OR REPRODUCED BY
ANY MEANS WITHOUT THE EXPRESS, WRITTEN CONSENT OF EEC.
MAC Address
When changing any of the network configuration options you may be asked to enter the 12 digit
Ethernet MAC address of the module if the module does not have a valid MAC address stored in flash.
Each DRCP processor module has a unique MAC address assigned to it. This address can be found on a
label atop the module processor board as illustrated below.
ETHERNET MAC ADDRESS LABEL
In most cases entering of the MAC address will not be required.
Additional Configuration
Besides network configuration it is necessary to configure a few other operating parameters.
Wait
The Wait menu item controls how long the processor waits in seconds before beginning execution of the
application stored in flash.
Boot To
The Boot To menu item controls whether the processor boots to the application software or the monitor
application. This option should be configured to Boot To Application for normal operation.
Exceptions Cause
The Exceptions Cause menu item controls how the monitor firmware will handle exceptions in the appli-
cation firmware. This option should be set to Exceptions CauseReset.