User's Manual

CHAPTER 8 INTERFACE CONTROL DOCUMENTS (ICD)
APPENDIX A INTERFACE CONTROL DOCUMENTS (ICD)
ISSUE/REVISION DATE: 25 JULY 2007 TECHNICAL MANUAL
ISO 9001:2000 PROPRIETARY
Interface Control Document (ICD) ENTERPRISE ELECTRONICS CORPORATION
Rev No. 5 Page 18 of 21
Issue Date 25 July 2007 UM-130365
Distribution Data Collection
Module (DDC)
THE DATA PRESENTED HEREIN REPRESENTS THE INTELLECTUAL PROPERTY OF ENTERPRISE ELECTRONICS CORPORATION (EEC). THIS DATA MAY NOT BE DISTRIBUTED OR REPRODUCED BY
ANY MEANS WITHOUT THE EXPRESS, WRITTEN CONSENT OF EEC.
Watch Dog
The Watch Dog menu item enables or disables the on chip watchdog timer. This item should be enabled
after downloading the application firmware. If this option is enabled and changes need to be made via
the boot monitor console, this item should be changed and saved first. Failure to disable the watchdog
will result in the repeated resetting of the processor while in the boot monitor console
.
Quiet/Loud Boot
The Quiet/Loud Boot menu item toggle configures whether the monitor should display the “Waiting to
start message” at boot time. When the menu item reads Quiet Boot the module will display the boot
message and selecting the menu item will toggle it to quite mode. When Loud Boot is displayed, the
boot message will not appear and selecting the menu item will toggle it to loud mode. This option is
used when the NetBurner’s COM0 is used to drive an external device such as a LCD panel and if you do
not wish to see the boot message on the device.
Application Firmware Download
To download the application firmware into flash follow the steps to enter the console monitor prompt
above. Once at the console monitor prompt the application software can be downloaded to the module
using the fla command. This command instructs the module to await transfer of the compressed S record
application image. The module will respond with Begin Down load now… as seen in the figure below.
DOWNLOAD COMMAND