User's Manual

Locks and Security
To replace the batteries:
1. Take a regular flat head screwdriver with a ¼” wide head and
insert it into the slot on the right side of the keypad. Gently twist
the screwdriver to pry off the top cover. Pull cover off by pulling
to the left and then up. The top cover and the guts of the keypad
will come off the vehicle and the back cover will remain mounted
to the vehicle.
2. Remove guts of keypad from top cover and place the top cover
on a soft surface to avoid scratching the decorative finish. Be
careful not to remove the silicone rubber membrane from the rest
of the electronics.
3. Take same regular flat head screwdriver with a ¼” wide head
and insert it into one of the two slots on the metal battery holder.
The two slots are on either side of the (+) sign of the battery
holder. The battery will then slide out enough to grab with your
fingers.
4. Pull the old battery from the unit and replace with the new
battery. Be sure that the battery is seated completely in side the
battery holder.
5. Replace the keypad guts back inside the top cover, making sure
the screwdriver slot is located next to the 9/0 key.
6. Hold the top cover and the keypad guts together, align the unit
with the back cover mounted on the vehicle, and gently press the
two pieced together. Gently run your finger around the perimeter
of the keypad to assure it is properly seated.
7. Press the 7/9 key simultaneously to lock the vehicle and to
verify that the unit is now functioning again.