User manual

2. Under the Password section, your existing password which is used to access the
device using the WEB interface will be shown.
3. To change your password, click on the Change Password box.
4. After you enter your new password in the active text fields and click Update button,
your new password will be shown.
Not: If you committed any changes on the system settings, all of the changes will be
installed with the new password.
2.3 Reading/Changing the Configuration using the WEB interface
You can also configure the EMG Series device using the WEB interface. Using the port 80 of
the HTTP protocol on the gateway, you can access the device settings from a remote
computer. The only option you can not change using the WEB interface is the “Disable WEB
Access” option.
1. enter the IP address of your device to the address bar of your preferred browser. If you are
connecting from an outside network, enter the IP address of your modem. In this case, the port
80 on the modem must be forwarded to the IP address of the EMG Series device.