User manual

2.1.1 RS485 Serial Communication Parameters
EMG Series device uses these parameters along with other units to which the device is
serially connected. For high performance communication, all the device parameters over
an RS-485 network must be configured the same.
2.1.1.1 Baud Rate
Defines the communication speed of the device. Supported rates are: 1200,
2400, 4800, 9600, 19200, 38400, 57600, 115200 bps.
2.1.1.2 Data Bit
Defines the data packet size. Supported bit values are: 5, 6, 7, 8.
2.1.1.3 Stop Bit
Stop bits come after the data and parity bits in serial communication protocols and
indicate that the data packet has ended. Supported stop bit values are: 1, 1.5, 2.
2.1.1.4 Parity Bit
Parity bits are used to verify the data packets. Supported values are: Even, Odd, None
2.1.1.5 Time-Out
Time-out defines how much time the EMG Series device will wait for a response
from the queried unit.
2.1.1.6 Delay (for EMG02 and EMG12)
When monitoring from more than one place is in effect, this value defines the wait
time for the response of queries to be sent to each connected device. This time value
may differ according to the device attributes.
2.1.2 Network Parameters
The settings in this section are related to the communication of the ENTES EMG Series
device over the internet/intranet infrastructure.
2.1.2.1 Connection Settings
EMG Series device can work in both server or client mode. If you want to establish a
remote connection to the EMG Series device, select the “Listens for connection
requests” option. If you want the EMG Series device to connect to the server and
operate as a client, select the “Connects to remote server” option.