User manual

9 10
Main Menus
There are 3 main menus on the device. These menus are RS-485, PASSWORD and ESCAPE. When SET
button is pressed for 3 seconds on the monitoring screen, main menu is accessed. Sub-menus are
accessed while on any main menu by pressing set button. If the password protection feature is active, a
password* will be asked before entering the main menu when set button is pressed for 3 seconds.
* Factory setting for password is 1234. Enter your password with Up, Down and Set buttons. Finally, main
menu will appear when you press the Set button. By using Up and Down buttons, you can browse main
menu options. The device does not get blocked when the password is entered incorrectly.
Committed changes are saved to device memory and do not get lost in case of a power outage.
If none of the buttons are pressed for 20 seconds while on the menu, monitoring screen is displayed. Any
committed change will be discarded.
In order for a change that you made in the menu to take effect, you must approve the Save
query. Otherwise, committed changes will not take effect..
2.1.1. RS-485 (Information for communicating with a PC) Menu
The device has MODBUS RTU communication protocol. All measured values can be transferred to a PC
by using the EPC-12 configuration software. Also, you can adjust all the settings that you can adjust directly
from the device except Counter Set by using this configuration software on a PC. In order for the
communication with a PC to occur; Baud Rate, Parity, Address values must be entered on the device.
Baud Rate
9600
RS-485
Parity
No
Address
001
Counter Set
Disable
Back
Monitoring Screen
press
for 3 seconds
RS-485
PASSWORD ESCAPE