Instructions

43
1. Push the SET button while the PulS dUrAtIon is selected on the screen.
2. Select the pulse width to be generated by the device in 0.01 second steps as shown in the screen
above.
3. Exit from the menu after completing your selection.
4. Do not forget to save your settings before leaving the menu by means of the BACK button.
Pulse Duty Factor Adjustment for Pulse Output
In this section, the time that the pulse will stay at the logic-1 level is set.
1. Push the SET button while the PULSE dUtY is selected on the screen.
2. Select the duty factor of the pulse to be generated by the device in 0.01 second steps as shown in
the screen above.
3. Exit from the menu after completing your selection.
4. Do not forget to save your settings before leaving the menu by means of the BACK button.
Operating Time Settings
In this section, it is described that the time passes where the device exceeds an adjusted value of a
chosen parameter.
The parameter is selected from the Time counter screen of the programming menu. For example, if VLN
is selected, the screen is displayed as below.