Instructions

47
4. You can save alarm parameters separately for 4 different alarms.
5. Do not forget to save your settings before leaving the menu by means of the BACK button.
Hysteresis Setting of the Alarm
In this mode, the hysteresis value required for defining an alarm is set. This setting is done in order to
prevent that the device does not continuously turns into alarm mode in little changes around the
threshold level. As in the following example, when the 2% value is selected, the alarm parameter value
should be changed at 2% in order to get out of the alarm mode.
1. While, the Alarm Enable is chosen, switch to the Alarm Hyst screen by pushing the up arrow
button.
2. Set the desired Hysteresis value in % by using the SET button and the direction buttons.
3. Push the SET button after completing your selections.
4. You can save alarm parameters separately for 4 different alarms.
5. Do not forget to save your settings before leaving the menu by means of the BACK button.
Alarm Delay Time Setting
1. After the alarm hysteresis screen, the Alarm delay time for activation is determined by pushing
the SET button.
2. The delay time in seconds is set by pushing the low and up arrow buttons and switching between
the digits through the SET button.
3. After, the Alarm source exceeds the limit, an ALARM is generated for the time adjusted at that
phase if there is any border violation.
4. The alarm release time is determined in the following screen by pushing the down arrow button.
5. The minimum time to pass for releasing an alarm is selected in the release time screen by
pushing the SET button.
6. The alarm is not released for the time where the parameter value is set here unless it exceeds
the threshold + hysteresis value.
7. Adjust the desired time value in seconds by using the down and up arrow buttons.
8. Do not forget to save your settings before leaving the menu by means of the BACK button.