Instructions

35
Output Parameter Settings
Digital output of the device can be used for one of the following applications:
1. Output as Pulse: When this option is selected, the device creates output pulses depending on
selected value of active or reactive energy consumption.
2. Output as Alarm: When this option is selected, the output changes from logic-1 to logic-0 if the
selected parameter exceeds or is below the limit value.
When the alarm condition is resolved, output returns to logic-1.
3. Output as Remote Control: When this option is selected, the user can change the output of the
device from logic-1 to logic-0 remotely via RS-485 communication.
This option can be used to control a circuit remotely.
1. Press the SET button while on Outputs menu.
2. Select the relevant output number and press the SET button to start the selection.
3. Select an output operation type mentioned above by using UP/DOWN buttons.
4. When exiting from the menu with the BACK or ESC button, don’t forget to save the changes.