User's Manual

URC PLUS User’s Guide
Copyright 

 2009 Entone, Inc. All rights reserved .
10
V2.3 for URC Plus v3.8
3. Select the decoder to register by:
 Press “1” to register URC PLUS to decoder 1.
 Press “2” to register URC PLUS to decoder 2.
 Press “3” to register URC PLUS to decoder 3.
After you enter a registration event, the “STB” button backlight on the URC PLUS will blink twice to
indicate that the registration process was successful.
The Hydra front panel will display “RC REG Dx” to indicate that the registration process was successful.
Figure 2-9 Remote Registration Successful
Pressing a key other than “0”, “1”, “2”, “3” or a button is not pressed within 10 seconds, the “STB”
backlight will extinguish and the URC PLUS registration process will be terminated.
4. If the Hydra does not receive any URC PLUS registration event within 30 seconds, the process will be
terminated.
The Hydra front panel displays the following messages during remote control registration:
Front Panel Message Description
RC REG TO Registration times out
RC REGERR Registration error
RC REG In registration mode
RC REGEND Registered to IR only mode
RC REG D1 Registered to decoder 1
RC REG D2 Registered to decoder 2
RC REG D3 Registered to decoder 3
Table 2-1 Remote Registration Messages
NOTE:
 While the URC PLUS is in “STB” mode, the volume +/- and MUTE key signal will be sent to the TV.
 By Default, if the URC PLUS is in “STB” mode, the POWER key signal will be sent to the STB ONLY.
 If the URC PLUS is in “TV” mode, the “POWER” key signal will be sent to the TV ONLY.
 However, the POWER key can be configured to control both the STB and TV while the URC PLUS is
in “STB” mode, please refer to the section “Toggle Power Key Punch Through Functionality” in Chapter
4 for details.