User's Manual

URC PLUS User’s Guide
Copyright 

 2009 Entone, Inc. All rights reserved .
22
V2.3 for URC Plus v3.8
Appendix B – Other Features
Showing URC PLUS Firmware Version
The URC PLUS firmware version is in the format of x.y.z, where x, y and z is digit 0-9. Use the following
procedures to show the URC PLUS firmware version:
1. Press “STB”.
2. Press and hold “SETUP” for 5 seconds.
3. The “STB” backlight will illuminate.
4. Press “INFO” once.
5. The 3 digits of the firmware version (x, y and z as described above) will be displayed in the following
manner.
a. The “STB” backlight blinks to indicate the digit. One blink indicates 1, 2 blinks indicates 2, etc
until 9 blinks indicates 9. A 0 is indicates by a shot, long, short, long, short, long blink.
b. In between each digit, the “STB” backlight will be off for 1 second.
c. For example, the following blink pattern shows a firmware version of 2.0.4.
. . .-.-.- ....
In addition, the URC PLUS Firmware version will also be shown on the sticker at the back of the remote
control.