User`s guide

Amulet High Definition Television Receiver User’s Guide
• Restart the Amulet by switching off and on
the power supply. Press and hold the Down
arrow key on the front panel for until the
diagnostic screen is shown and beep sound
is heard.
If the box is booting up properly and the
video/au
dio connection is fine, this color bar
screen and sound should be displayed and
heard on all outputs (RF/HDMI/RCA
Composite/Component)
No sound
Section 5 – Connecting
to Audio Syst
em
• Check that the audio cable is connected to
the
correct input in your device.
• Is the volume of the device turned down to
the mi
nimum level?
• If HDMI or component is used. Try disabling
AC-3.
• If HDMI is used, check the resolution and try
to u
se the composite audio output.
Multi-channel
sound not
working
Section 5 – Connecting
to Audio Syst
em
• Check with service provider that programs
co
ntain multi-channel AC-3 signal.
• Check that AC-3 is enabled in the Amulet.
• Check your TV or A/V equipment for AC-3
multi
-channel setup.
No sound, poor
sound or
popping noise
on HDMI
Section 4 – Connecting
the TV
• HDMI is an evolving technology, so it is
po
ssible that some TVs may not operate
properly with Amulet. In case of problem, use
component video output and composite audio
output to connect your primary TV.
Copyright © 2009 Entone, Inc. All rights reserved .
36
V1.9