Operation Manual

URC 4 User’s Guide



v2.5 for URC 4

Chapter

1.1 Introduction

The Entone Universal Remote Control v4.x (URC 4) is designed to work either on Radio Signals (RF) or InfraRed (IR).

It can control Janus Media Hub using RF from another room where is not at direct sight distance from the Janus. Or, it

can use IR to control Amulet High Definition IP Television Receiver at direct sight distance. The URC 4 can also be

used to control other A/V devices such as TV, DVD player and audio equipment using IR. There are two types of

Entone URC 4: IR only (IR URC) and IR+RF (RF URC). IR URC is included in the package of Janus/Amulet while RF

URC is included in Entone Second Stream Kit.

Loading Batteries

The URC 4 comes with AA-size batteries, which need to be installed when you first receive your system. When

you replace old batteries, you should replace all of the batteries. Use batteries of the same kind, for example

alkaline or carbon zinc, and do not mix batteries of different kinds. Alkaline batteries last longer than carbon zinc.

Warning: Mixing old and new batteries or different types of batteries poses a fire hazard.

To load batteries to URC 4:

1. Press down on the battery cover’s top latch and slide the cover off.

2. If you are changing out batteries, take out all of the old batteries.

3. Put the new batteries in. Make sure you match the plus ( “+” ) ends with the plus markings on the battery

case.

4. Slide the cover back into place.

Figure 1-1 Loading Batteries to URC 4