Operation Manual

URC 4 User’s Guide



v2.5 for URC 4

RF URC Registration

You may need to register the RF URC to the STB before you can use the remote. The RF URC registration

procedures may vary for different middleware and TV service running in the Entone STB. Please refer to

the TV service user guide for detailed RF URC registration procedures.

Below lists the general RF URC registration procedures (NOTE: Refer to your TV service user guide for

exact RF URC registration procedures):

1. Press and hold the “OK” button on the STB front panel for 5 seconds until the touch panel backlight is

flashing. The STB is now in URC registration mode.

Figure 2-5 Janus in Remote Registration Mode

NOTE: If registration is not completed in 30 seconds, the touch panel backlight will stop flashing.

2. Press “STB” button once on the URC.

3. Press and hold the “STB” button on the URC for 5 seconds until the “STB” button backlight is on.

4. Press “STB” button once again. Both the “STB” and “AUX” button backlight will illuminate.

5. Press “1” or “2” to register the URC to output 1 (primary) or output 2 (secondary) (depending on the

middleware).

Upon successful registration, the STB POWER indicator will flash once and the touch panel backlight

will stop flashing.

NOTE:

 The POWER key can be configured to control both the STB and TV while the URC 4 is in “STB” mode,

please refer to the section “Toggle Power Key Punch-through Functionality” in Chapter 4 for details.

 The Volume +/- and MUTE key can be configured to control both the STB and TV while the URC 4 is in

“STB” mode, please refer to the section “Toggle Volume Key Punch-through Functionality” in Chapter 4

for details.