Operation Manual

CROSS3E - IP1780
12
2. REFERENCE TO ILLUSTRATIONS
The given operating and performance features can only be
guaranteed with the use of DITEC accessories and safety
devices.
2.1 Standardinstallationreferences(g.1)
[1] Radio
[2] Flashing light
[3] Key selector
[4] Geared motor + control panel
[5] Photocells
[6] Rubber edge - sensitive edge
[7] Opening and closing stop
[8] Connect power supply to an type-approved omnipole
switch with a contact opening gap of no less that 3 mm
(not supplied).
Connection to the grid is made with independent channels
and separated from the connections to the control and
safety devices.
2.2 Gearedmotorreferences(g.2-3)
[9] Casing
[10] Control panel
[11] Motor
[12] Transformer
[13] Manual release
[14] Safety micro
[15] Base plate
[16] Line fuse
[17] Pinion
2.3 Accessories
[18] BATK3 Battery kit
[19] LUXK3E Courtesy light kit
[20] CROSSCRN2 Rack
[21] CROSS3TC Chain drive kit
[22] CROSS3SF Photocell support kit
3. INSTALLATION
Unless otherwise specied, all measurements are expressed
in millimetres (mm).
3.1 Preliminary checks
Check the stability of the wing (derailing and lateral falls) and
the sliding wheels and that the upper guides do not cause any
friction.
The sliding guide must be securely xed to the ground for the
full length within the doorway and must have no irregularities
that could hinder the movement of the gate.
The opening and closing stops must be tted.
Note: make sure that the gate can not exit the sliding guides
and fall.
If the gate has slits, make sure they are covered to prevent
shearing points.
Safety device should be installed at the end of the wing to reduce
the collision force.
3.2 Base plate position
- Insert the anchoring brackets into the base plate [15] and
secure them by means of the nuts provided.
1. TECHNICAL DATA
CROSS3E
Power supply 230 V~ / 50-60 Hz
Absorption 1.2 A
Thrust 150 N
Max run
7 m
5.7 m [CROSS3TC]
Openingspeed 0.12 - 0.25 m/s
Closingspeed 0.12 - 0.25 m/s
Acquisition speed 0.10 m/s
Maxdoorweight 300 kg
Service class 3 - FREQUENT
Min number of
consecutive cycles
50
Intermittence
S2 = 15 min
S3 = 50%
Temperature -20° C / +55° C
Degreeofprotection IP24D
Control panel 73RP
GB