Installation Guide

23
SP Series Info Central: Setup
6 Select the Apply Changes button to make the values take effect in the printer, OR select the Cancel Changes
button to return to the values displayed before you used the slider.
— The “Changes saved to printer” message appears when the values have been saved to the printer.
7 Select the Print Sample Card button.
8 Mark the card on the back with a 2 (or the next sequence number if repeating these steps) and the new settings
(such as 18/50/-1).
9 Evaluate the result as shown on the printed card.
— If the new setting has solved the problem, you can select another value to change or be done.
— If the new setting has not solved the problem, return to step 5 and repeat the process.
— If the new setting has made the problem worse, return to step 5 and move the slider to the value for the print
position written on card 1.
Change laminator settings (SP75 only)
Change the temperature or speed used to apply patch or topcoat material to cards if needed to improve card
quality. Change the Supply registration, Card registration, or Apply length to fine-tune the placement of material on
the card.
Tips for success
• These steps apply only to an SP75 printer, which includes one or two laminators.
• Begin with the printer connected to the PC and powered on.
• Make small changes in settings to avoid breaking the laminator material.
• You can use the mouse or the arrow keys (><) to move the slider.
• Do not change laminator settings unless requested to do so by your Datacard®-authorized service provider.