User's Manual

Visit Datacard.com/id for downloads and support.
The design and information contained in these materials in protected by U. S. and international copyright law and/or treaties.
XPS Card Printer Guide
Printer Guide
About the Printer
Printer
Components
Printer System
Printer
Configuration
Label
Site
Requirements
Tasks and Users
Using the Printer
Card Design and Setup
Printer Driver
Printing Cards
Troubleshooting
Supplies and Parts
Installation Guide
Site Requirements
Set up and use the printer in an environment that meets the following requirements.
Provide space for the printer and for
clearance around the printer. The
minimum required space is:
8.5 inches (216mm) from side
to side
17 inches (432mm) from back
to front
14 inches (356mm) from the
desk or other surface
Place the printer in an environment with
temperatures ranging from 60° F to 95°
F (15° C to 35° C).
Use a single phase, 3-wire, grounded
receptacle.
Keep all dust, dirt, food, and liquids
away from the printer.
Keep paper and foreign materials off the printer.
Place the printer on a sturdy, level surface.
Place the printer away from direct sunlight.
Do not place printer near heating ducts, fans, or other air vents.
Do not use the printer for purposes other than the intended use.
Prevent debris from entering the printer.
Place the printer in a clean office environment, protected from any type of construction.
Electrical Requirements
The power supply is rated as follows:
100-240 Volts, AC
50-60 Hz
3.0 Amps
The power supply is autodetecting and works within the range stated.
XPS Card Printer Guide
DRAFT
2/22
Datacard Confidential
Page 9
SHORT TERM CONFIDENTIAL