User's Manual

4. Press Enter to end a line.
5. Repeat Steps 3 and 4 for each track of magnetic stripe data.
End each line with an Enter keystroke.
Do not not put data for two tracks on the same line.
Do not allow text to encode to wrap to another line.
You can use two or more lines of text for one track. Each line must start
and end with escape codes. The driver will add (append) lines for the
same track together.
Data to encode can be on side 1 (front) or side 2 (back) of the card.
6. With magnetic stripe cards in the printer, send the card to print.
7. Verify the encoding success by passing the card through a card reader.
Hints & Tips
The driver recognizes all supported
escape codes.
Use a small font size to shorten lines
of text to encode.
Keep text to print on a different line
from text to encode.
When the driver adds lines of text for
the same track, the sequence is
determined by the application. Test
your application with the driver to
make sure the data is in the correct
order.
Magnetic stripe data sent by the driver
is always encoded on side 2 of the
card.
XPS Card Printer Guide
DRAFT
2/22
Datacard Confidential
Page 45
SHORT TERM CONFIDENTIAL