User's Guide

CR805 Retransfer Card Printer User’s Guide 103
277: Multi-hopper pick error
The multi-hopper did not pick a card from the input hopper cartridge.
1. Unlock the multi-hopper.
2. Remove each cartridge and make sure that cards are loaded properly.
3. Make sure that the cartridges are installed correctly.
4. Check the exception slide.
5. Lock the multi-hopper.
Press the U
SER button to clear the error.
On the PC, click Retry, or click Cancel to cancel the card.
278: Insert cleaning card in H2
1. Unlock the multi-hopper.
2. Remove unused cards and insert the cleaning card in hopper 2.
3. Close and lock the multi-hopper.
4. Press the printer’s U
SER button to pick the card.
On the PC, click OK, or click Cancel to cancel the card.
Laminator Messages
The following messages display on the printer LCD panel when you are using a laminating system.
They also display in a message on the PC that issued the card print job when you use the Card
Printer Driver.
177: Laminator not available
The printer and laminator cannot communicate. The card will be canceled.
1. Make sure the data cable from the laminator to the printer is securely plugged in.
2. Press the printer P
OWER button to power off the system.
3. Press the P
OWER button again to power on the system.
On the PC, click Retry, or click Cancel to cancel the card.