User's Guide

A-4
Inside the Laminator
The CLM laminator has one standard laminator, in the L1 position, with an optional second
laminator in the L2 position. The laminators apply a patch overlay material to the card. The patch
overlay is a die-cut polyester shape designed to fit standard ISO ID-1 size card stock. Both
laminators can apply the overlay. Refer to “Laminator Overlay Materials” on page A-6.
Manual Advance Knobs The manual advance knobs move the card through the
laminator to remove it from the system. Use the knobs to
clear a card jam.
L1 Laminator (green
cartridge)
The L1 laminator cartridge holds the overlay material and
applies it to the card.
L2 Laminator (orange
cartridge)
The L2 laminator cartridge holds overlay material and applies
it to the card. The L2 laminator is optional.
Reject Tray Release
Button
The release button opens the reject tray at the back of the
laminator and allows you to remove incomplete cards.
Laminator Access Door The access door provides access to the L1 and L2 laminators
to load supplies or to clear a card jam.
L2 Transport Access Door The L2 transport access door replaces the L2 laminator
cartridge if the optional second laminator is not installed.
Open the door to access the laminator card transport.
If your system includes the optional second laminator (L2), make sure that the
laminator cartridge is always installed even if the cartridge is not loaded with overlay
material. If the cartridge is not in place, cards are not supported as they travel through
the system and can fall into the bottom of the laminator.
Manual Advance
Knobs
L2 Transport
Access Door
L1 Laminator
Laminator
Access Door
L2 Laminator
Reject Tray
Release Button