User's Guide

CR805 Retransfer Card Printer User’s Guide 27
3. Press the down arrow until the address method used by
your network displays on line 2.
 DHCP
 SLAAC
 Manual
 Local
Press ENTER to display the IP address.
An IPv6 address is represented as eight groups of four
hexadecimal digits separated by colons. The address
requires 39 characters to display. Because the LCD is limited
to 16 characters per line, the IPv6 address is spread across
three screens of the LCD. You can press either the down
arrow or the E
NTER key to display the next section of the
address. A digit at the end of line 1 indicates which section of
the address is being displayed.
4. Record the address.
5. Press the down arrow until Exit displays on line 2.
6. Press E
NTER. Then, press the USER button to return the printer to Ready. The USER button glows
green.
The example shows the LCD display for an IPv6 Manual address. DHCP, SLAAC,
and Local addresses behave the same, as does the gateway address for a manual
address.
A stateless (SLAAC) configuration (if enabled) can have multiple values depending
on the router setup. The LCD displays up to four SLAAC addresses. An additional
digit in line 1 indicates which address is being displayed.