User's Guide

52 System Maintenance
Multi-Hopper Printer
1. Power on the printer, if necessary.
2. Remove the ink ribbon and retransfer film cartridges. Refer to “Replace the Ink Ribbon” on
page 34 and “Replace the Retransfer Film” on page 38.
3. Unlock the multi-hopper.
a. Unlock the multi-hopper door lock (a).
b. Slide the lock bar release button (B1) to the left to
release the hopper lock bars (b).
c. Rotate the center lock bar to the left to provide access
to the H2 and H5 multi-hopper input cartridges (c).
4. Press the cartridge release button at the top of the H2
cartridge and open the cartridge door (d).
5. Lift the card weight to the top of the cartridge and
gently pull it forward until it locks in position (e).
6. Remove the unprinted cards from the H2 cartridge (f).
Handle the cards by the edges only, or wear card
inspection gloves approved by Entrust Datacard.
7. Peel off the center strips on both sides of the adhesive
cleaning card. Leave the side strips in place.
a
b
c
d
e
f
Peel Off Center
Strips Only