Operator's Guide

6 Introduction
Physical Requirements
The following section contains the physical site requirements needed for a
PB8500 system.
Floor Space
The floor space required to install the system is dependent on the number and
type of modules included. To determine how much floor space is required,
calculate the following:
1. Controller width + [number of input and output modules x input/output
width] + [number of inkjet modules x inkjet width)] + (number of standard
modules x standard width) = Total width of system
2. Total width x 33.8-inch (85.9-cm) depth = Floor space used by system
3. Floor space used + 36-inch (45.72-cm) clearance on all sides for service
access and airflow = Total floor space
The floor must be level and flat within ± 0.1 inch per foot (1 mm per 10 cm) in
any direction.
System Dimensions
The dimensions and footprint values for the overall system are the sum of those
for the Controller and each module. Dimensions are as follows:
Module Width/Height/Depth
Controller 24 x 37.1 x 31.7 inches
(61 x 94.2 x 80.5 cm)
Standard PB8500 Module 10 x 50.3 x 26.9 inches
(25.4 x 127.8 x 68.3 cm)
Input and Output Modules
(The final Output module has an
end panel that makes the module 11
inches wide.)
10 x 42 x 33.7 inches
(25.4 x 106.7 x 85.6 cm)
Pretreat Module 10 x 50.3 x 42.8 inches
(25.4 x 127.8 x 108.7 cm)
DOD Module 50 x 53.8 x 35.3 inches
(127 x 136.7 x 89.7 cm)