Operator's Guide
Table Of Contents
- PB8500 Operators Guide
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: System Power On and Power Off
- Chapter 3: Load Supplies
- Chapter 4: Production
- Chapter 5: Preventive Maintenance
- Chapter 6: Troubleshooting
12 System Power On and Power Off
Procedure
1. Plug the system into AC power.
2. Turn on the Controller PC by pressing the power button on the front of the
computer. Allow the Controller PC to boot up completely.
3. Log on to Windows.
4. Start the Controller software, and go to the Production screen. It displays
the progress of the system during startup and, eventually, a diagram of the
system.
5. Power on the system hardware by rotating the E-stop switch on the front of
the Controller module clockwise to the ON position. This switch controls all
AC power to the modules, the cooling fans, and all additional power cords
that are installed on the system.
Do not use the keyboard or mouse during Windows start-up.
You can use the E-stop switch to stop the system in an
emergency.