Operator's Guide
Table Of Contents
- PB8500 Operators Guide
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: System Power On and Power Off
- Chapter 3: Load Supplies
- Chapter 4: Production
- Chapter 5: Preventive Maintenance
- Chapter 6: Troubleshooting
18 Load Supplies
Adjust for Change of Booklet Thickness
When you load thicker or thinner booklet stock, you may need to adjust the
Input Module so that the booklet separator picks only one booklet at a time.
Adjustment Procedure
1. Place two booklets into the stacker and move them forward until they both
line up with the edge of the booklet separator.
2. Loosen the adjustment knob (2).
3. Move the booklet adjuster (1) forward or back until it is in the center of the
second booklet. In this position the first booklet can pass, but the second
booklet is blocked.
4. Retighten the adjustment knob (2).