Operator's Guide
Table Of Contents
- PB8500 Operators Guide
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: System Power On and Power Off
- Chapter 3: Load Supplies
- Chapter 4: Production
- Chapter 5: Preventive Maintenance
- Chapter 6: Troubleshooting
Operator’s Giude 55
Clean the exterior
components of
the Controller
As needed
1. Clean the monitor with a soft cloth
dampened with water. Immediately wipe
the monitor dry with a clean cloth. Refer
to the monitor’s manual for more specific
instructions.
2. Vacuum the keyboard. If necessary, wipe
the keys with a cloth dampened with
water. Never let liquids spill on the
keyboard.
3. Remove the track ball from the mouse
and wipe with a lint-free cloth.
4. Wipe the outside of the whole system
with a clean cloth dampened in a mild
detergent.
Clean the
Controller module
filter (also the air
filter on the
Output module, if
present)
Monthly Clean the filter over the fans on the side of
the Controller whenever it gets dirty, and at
least once per month.
Pull the flexible filter away from the
Controller and vacuum it on both sides.
Procedure Frequency Comments