Operator's Guide

Operator’s Guide 61
Secure Overlay
Use the following procedure to extract a jammed booklet from the Secure
Overlay module.
1. Lift the module hood.
2. If necessary, manually push the platen carriage away from the booklet jam.
3. Use your hand to dislodge the jammed booklet.
4. Use the green booklet advance knobs to move the booklet out of the Secure
Lamination module.
 If the booklet is near the entry-side of the module, turn the input roller
knob counterclockwise to push the booklet into the upstream module.
Refer to (1) in the figure below.
 If the booklet is near the exit-side of the module, turn the tabbed belt
knob (2) counterclockwise to push the booklet into the downstream
module.
5. Remove the booklet from the system.
Warning: Always allow the platen assembly to cool or wear
protective gloves before handling the platen shoe or internal
components. Press on the sides of the perforated guard shield when
moving the platen carriage.
Caution: Be careful not to wrinkle or rip the supply material. If
necessary, add some slack to the supply material with the take-up
capstan knob.