Instructions / Assembly

Helpful Tips

To ensure proper ignition make sure the igniter pin is properly positioned

and connected.

- The igniter pin should be pointed straight to the thermocouple.

- The thermocouple should be positioned 5mm away from the burner tube.

Make sure that the pilot housing is unobstructed.

Clear any debris on top of the pilot housing and make sure there is no debris

between the igniter pin, thermocouple and the burner tube.

If the burner will not light or stay lit,

please perform the following checks.

Turn the control knob to oﬀ and close the LP Gas tank valve. Disconnect the

regulator. Turn the Control Knob to “HIGH”. Wait a minimum of 5 minutes.

Turn burner control knob back to “OFF”. Reconnect the regulator and perform

a leak check at tank connection. Turn the LP Gas tank valve on slowly, wait 30

seconds and then light the outdoor ﬁre table.

It is possible that the Excess Flow Safety Device has been tripped.

Make sure

the wires are

fully inserted

into the

ignitor box.

If wires are too

close, or

tangled, they

could short.

Make sure they

are spaced

apart from

each other.