Owner`s manual

DOOR LATCH (2-3 days)

Check the door latch every time the door is opened or closed to ensure proper movement.

ASH PAN AND DOOR GASKETS (weekly)

After extended use the gasketing may come loose. To repair this, glue the gasketing on using high-

temperature fiberglass gasket glue available from your local ENVIRO dealer. This is important to maintain

an airtight assembly.

ASH PAN (weekly)

IMPORTANT: The unit must be OFF while the ash pan is removed. Sweep the ashes from the firebox

through the grate into the ash pan.

The ash pan is located under the burner and has a latching mechanism to secure it, simply turn the knob

and pull out towards the front. If the ash pan is hot and/or dirty, gloves should be worn to remove it. Pull

the ash pan out. When the ash pan is out of the unit lift the ash pan by the front and back handles and

carry the ash pan to where the ashes will be emptied.

Dump the ashes into a metal container stored away from combustibles. Monitor the ash level every week.

Remember that different pellet fuels will have different ash contents. Ash content is a good indication of

fuel efficiency and quality. Refer to “SAFETY WARNINGS AND RECOMMENDATIONS” for disposal of ashes. Vacuum

the inside of the ash pan compartment inside the pedestal including the hole at the top back of the

compartment. Replace the ash pan and close pedestal door. DO NOT PLACE UNBURNED OR RAW

PELLET FUEL IN ASH PAN.

EXHAUST PASSAGES (biannually)

Removal of the firebox backing for bi-annual cleaning (refer to Figure 8):

Routine Cleaning and Maintenance

• Open the door by lifting the handle.

• Remove the burn pot and burn pot liner.

• Lubricate all screws with penetrating oil.

• Remove the four (4) screws that hold the

brick liner retainers in place. Remove side

brick liners by sliding them forward then

out.

• Pull the center panel out.

• Vacuum and clean thoroughly.

Installation of firebox backing:

• Insert center panel with backing.

• Place the two (2) side panels back into the

firebox and reinstall the two (2) retainers

using two (2) screws on each side.

• Replace the burn pot and burn pot liner

• Close the glass door and secure.

FRESH AIR INTAKE (annually)

Inspect periodically to be sure that it is not

clogged with any foreign materials.

Figure 8: Firebox Components Removal.