Operating instructions

OPTIONAL FAN INSTALLATION
The appliance when installed must be electrically connected and grounded in accordance with local codes or in
the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE. Part 1, SAFETY
STANDARDS FOR ELECTRICAL INSTALLATIONS, or THE NATIONAL ELECTRICAL CODE ANSI / NFPA 70 in
the USA.
CAUTION
Label all wires
prior to
disconnection
when servicing
controls. Wiring
errors can cause
improper and
dangerous
operation. Verify
proper operation
after servicing.
1) Remove the fan assembly from the box and inspect
for any damage to the assembly.
2) Remove the metal knock out on the rear of the
appliance.
3) Install two screws into the top two holes. Place the
blower assembly over these two screws and tighten.
Install the two bottom screws and tighten.
4) Plug the fan assembly in and check for proper
operation.
DO NOT cut or remove the grounding prong from the plug. Also do not route the power cord beneath the heater.
WARNING: ELECTRICAL GROUNDING INSTRUCTIONS.
This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard and
should be plugged into a properly grounded three-prong receptacle.
WIRING DIAGRAM
This is a basic wiring diagram for the option fan
installation. Models 1000, 1600, 2100
freestanding units only.
1) Plug the fan assembly into a three prong
(grounded) receptacle.
2) Turn the fan controller to the desired setting.
3) Once the unit has reached operating
temperature, the fan temperature sensor will
turn the fan on automatically.
4) When the unit cools down the fan
temperature sensor will shut the fan off
automatically.
17