Operating instructions

PEDESTAL AND LEG INSTALLATION

Please read and understand these instructions before installing ash pan and leg option.

Failure to follow these instructions carefully could cause personal injury or property damage.

All screws are pre installed on the base of the unit.

PEDESTAL

• Remove the bricks from the unit before

starting.

• Loosen the two carriage bolts that secure

the unit to the pallet. Slide the pallet towards

the front to release carriage bolts from the

key holed slots in the unit. Place the unit on

the pallet on its back.

• Slide the pedestal assembly over the bolts

located on the base of the unit using the key

holed slots provided.

• Tighten all four bolts ensuring the pedestal

is properly aligned to the edges of the unit.

• Ensure that the gasket material is properly

sealed before continuing.

• Stand the unit on the pedestal and set the

unit in the location ready for installation.

• If fresh air supply is being supplied from the

bottom of the unit please install the cover

plate supplied to the rear of the pedestal

covering the 4” inch hole.

LEGS AND ASH PAN

• Place the unit on the pallet on its

back.

• Slide the ash pan assembly over the

bolts using the key holed slots

provided and tighten all four bolts.

• Ensure that the gasket material is

properly sealed before continuing.

• Carefully remove the cast iron legs

from the packaging and secure each

leg with two bolts provided.

• Secure all four legs, push the leg

towards the center of the stove and

align the legs with the outer edges of

the firebox.

• Stand the unit on the legs and set the

unit in the location ready for

installation