Owner`s manual

Initial Installation
QUALIFIED INSTALLERS ONLY
DiRect Vent moDeL:
WARNING: This appliance has been designed to draw room air for proper heat circulation
from the sides of the unit. Blocking or modifying the louvers in any way can create hazardous
situations.
Thismodelisventedwithtwo(2)3”aluminumorstainlesssteelexventsleadingintoaco-linearto
co-axialventadaptorandusingaverticalterminationcap.Theuecollarsofthismodelwilltinsideof
astandard3”ventandmaybefasteneddirectlytothevent.TheExhaustventisontherightoftheue
connector.TheAirIntakeisontheleftsideoftheventcollarplate(thisoutletisnotinthecenter,itisoff
toonesideoftheventcollarplate.)
Check periodically that the vents are unrestricted. Also ensure that all direct vent pipes have been
properlysealedandinstalledafterroutineinspectionorcleaning.Theairintakeandexhaustpipesmust
beinstalledinthecorrectlocationsontheremovableconnector.
PRePaRing youR sienna foR instaLLation:
• Remove the packaging from the appliance and surround panels; check to make sure there is no
damage.Carefullychecktheglassdoor.Donotusetheunitifitisdamaged.Intheeventdamageis
found,pleasereportittoboththecourierandyourdealerassoonaspossible.
• Carefullycleanthereplaceanduebeforeinstallingthestove.Failuretodosomayresultinfumes
ordirtbeingblownintotheroomandmaycauseareleadingtodeathorseriousinjury.
1. Removetheunitfromtheboxandremoveallpackagingmaterialfromtheappliance.
2. Removedoor.SeemaIntenance anD serVIce - glass Door remoVal.
3.Removelogandembersetandallwrappingmaterialfromthestove.Removewrappingmaterialfrom
logandembersandcheckforanydamage.Ifdamageisobserved,donotuseunitandcontactyour
localdealer.
4. Removetheventcollarplatefromthetopofthestovebyunscrewingthetwo(2)T-20Torxscrews
locatedonthecentertopofthestove. Slidethecollarplatebackwards.Ifthereplacethattheunit
istobeinstalledintoishigh,thecollarplatedoesnotneedtoberemoved.Properlysecurethevent
collarplatetotheexibleventpipeliner(s)previouslyinstalledinthechimney.Becarefulnottoover-
stretchtheliner(s).
5.Place the unit part way into the replace. Connect the replace insert’s exible gas line to the
householdgassupply,usinglocallyapprovedmethods.Placetheelectriccablesoitcanbeconnected
tothepowersupply.
15
6. As you pushthe unit into its nal position
inthereplace,iftheventcollarplatewas
removed,reinstallittothestovebysliding
italongthedrafthoodandsecurewiththe
screw.
7.
Adjustthelevelinglegstoensuretheunit
islevel.Therearetwo(2)levelinglegson
eachside(showninFigure19).
Leveling Legs
two (2) on each side
Figure 19: Leveling legs position.