Owner`s manual

21
Secondary Installation
Figure 30: Filler panel with trim installation.
instaLLation of suRRounD PaneL:
TheSiennamusthaveoneofthepanelsinstalledaroundtheunit;theunitpanel,thellerpanel,orthe
llerpanelwithtrim.Ifyouhavetrimforyourllerpanel,thetrimmustbeinstalledbeforeinstallingthe
Figure 29: Screw to
hold the trim against
the surround.
Surround Panel
Side
Trim
#8 screw
Surround
Panel
Figure 27: Corner brackets
for trim.
llerpanelontotheunit.Onlytrimkits,surroundpanels,andfacessupplied
bythemanufacturershallbeusedintheinstallationofthisappliance.Draft
ReliefOpeningsmustnotbecoveredorblocked.Theowofcombustion
andventilationairmustnotbeobstructed.
1.Attachonesidetrimtothetoptrimusingacornerbracket(seeFigure
27)tosecurepiecestogether.Therearetwo(2)mainpiecestoeach
cornerbracket(seeFigure28).Installthesecornerpiecesintothetrim
with the “B FACE” sides facing each other & the screw heads facing
outward. Align the side and top trim tightly together and witha at
headscrewdrivertightenthescrewineachcornerbracketintheside
trims,thentightenthetoptrim.
2.Slidethetwo(2)attachedtrimpieces
ontothesurroundpanel.
3.Attachtheothersidetrimpiecetothe
toptrimusingthesamemethodused
inStep1.
4.Place the second side of the trim
on the surround panel in the same
manner use on the rst side and
secure in the same manner.
5.On the side trims there are holes 2”
(50 mm) from either end. Using a
Phillipsscrewdriver,placea#8screw
1¼” long in each hole and tighten
(refertoFigure29).Thiswillkeepthe
trimtightagainstthesurround.
NOTE:Thenotchatthebottomofthelefttrim
issothepowercordcanberuntotheoutside
of the panel.
INSTALLATION:
Lift the surround upright in
front of the replace with the four (4) hooks
pointingtowardsthe replace.Slidethehooks
into their corresponding slots (see Figure 30).
Ensure the hooks are pushed all the way into
theslotsandthenotchonthehookmustbeon
thebottomoftheslot.Thesurroundshouldbe
wipedwithadampclothperiodically.
REMOVAL: Lift the surround straight up in
order to unhook the notch on the hooks from
the bottom of the slots. Pull the surround out
away from the replace. Place the surround
whereitwillnotbedamaged.
Figure 28: Two pieces of corner bracket.