Owner`s manual

25
Secondary Installation
RemoVing the bRick PaneL:
The brick panel set is fragile, handle with extreme care.
Thebrickpanelsetcomespre-installed.Thecentreandtoppanelaretheonlypanelsthatneedtobe
removedifthecompletegasandelectricaltrayassemblymustberemoved.Thesidepanelsmayremain
installedunlesstheyaretobereplaced.
1. Turntheunitoffandallowthe
unittocoolcompletely.
2.Remove the fascia or louvers,
openthedoor,andremovethe
logset.
3.Pull out the bottom of the
centre panel while pushing up
on the top panel.
4.With the center panelout,the
toppanelwilleasilycome out.
Justslidethetopedgebackout
ofthetoplipintherebox.
Ifthesideandfrontpanelsmust
be removed, continue with steps
5,6,7,and8.
5.Liftthefrontpanel,locatedon
the rebox bottom, from one
end and remove the panel at
an angle through the re box
opening.
6.Removethelogsupporttrayby
lifting the back of the tray up
and pull it out from under the
lip.Takecarenottoknockthe
pilotandthesidebrickpanels.
7.Remove the two (2) T-20
screws holding the bottom of
the bafe (shown in Figure
39).
8.Pull the panels out of the lips
atthe front ofthe rebox and
carefullyremovethepanelfrom
theunit(showninFigure40).
To re-install, follow the above
steps in reverse. Ensure that
the front and side panels are
pushed as far forward as they
canbebeforecontinuingwiththe
installation.
Figure 40: Brick Panel Installation.
Figure 39: Brick Panel Installation.
1
2
Figure 38: Brick Panel Installation.