Owner`s manual

23
Secondary Installation
GLASS REMOVAL:
In order to install the log set, and for regular cleaning, the glass door will need to be removed. With the face off,
glass
LOG SET AND EMBER INSTALLATION:
The placement of the logs is not arbitrary. If they are positioned incorrectly, the ames can be “pinched” and will
not burn correctly. The burner and a few of the logs come with locator pins, which make alignment easier. Using
the pictures provided, carefully set the logs in place (see gures 29 thru 34).
NOTE: The logs are fragile and should be handled gently. When removing the logs from their packaging
be careful and check that there are 5 large logs (back, left/center, left, right, and center) and 2 small
pieces before discarding of the packaging. One log may be covered by cardboard.
Maintenance: Once a year the logs should be removed and checked for deterioration or large amounts of soot. A
small amount on the bottom side of the logs is normal. Remove and replace the logs in the same manner described
above.
If new/more embers and rock wool is required, contact your nearest ENVIRO dealer.
Never operate the replace with the glass door removed.
there are two handles on either side of
the glass. They rotate 90° until parallel
with the oor. The top of the glass will
move away from the rebox and then the
glass door can be lifted off the resting
points.
To replace the glass door, simply reverse
the above procedure.
Warning: Do not touch or attempt to
remove the glass if the replace
is not completely cold.
WARNING: Never operate the
replace with the glass
removed.
Figure 28. Glass Removal Handle