Owner`s manual

Figure 33: Final Log Set Arrangement with Embers.

Secondary Installation

Figure 34: DV42DX Burning.

Figure 32: Fourth Stage Log Set Installation.

Figure 32: The left log rests on the left pin and

ledge of the back log and the back of the andiron.

Figure 33: The last log, center log, rests on the

end of the grate and on the ledge cut-out in the

center of the back log.

Once the logs are in place the embers can be

installed. Bags of ceramic ber embers and rock

wool are provided. The ceramic ber comes in

chunks that are about 2in (5cm) long. Place

them irregularly around the burner. When there

is a sparse but even layer of embers, spread the

rock wool in the same manner. DO NOT pack the

rock wool material as this could create an unsafe

condition. The pieces should be lightly placed so

they don’t completely block any of the tiny ports.

DO NOT allow any of the embers to rest against the

pilot assembly.

Caution: Use only the type of ember material

supplied with this replace. Due to the irregular

size of the ember material, there may be more

than required. Use of other foreign materials on

the burners may create dangerous conditions.

Figure 34: Refer to this gure when adjusting the

venturi and vent restrictor. Make adjustments so

that the ame reaches the approximate height

shown

NOTE: While the glass is still removed, it is

recommended that the gas line be purged by

lighting the pilot.

When lighting the replace for the rst time since

the log set and embers have been installed/

replaced, watch for ignition at ALL the burner

ports. If a long delay is noticed, turn the appliance

off and wait for it to cool down. Then remove the

glass and rearrange the ember material, making

sure none of the burner ports are blocked.