Home Security System User Manual

28 D-011-0152

Programming

Accessing the MAIN MENU for Programming

1. If not already powered up, apply power to the EA800 base unit. During the boot process:

■ The Winland Electronics splash screen is displayed.

■ The system verifies flash memory, as indicated by FLASH BOOT at the bottom of the screen.

■ The About screen is displayed.

■ The MONITORING screen is displayed. UNLOCK appears above the F1 soft key.

2. Follow the steps below to unlock the keypad and access the MAIN MENU screen.

Note: If the password entered was incorrect, the INVALID PASSWORD screen is displayed. If this happens, press

the OK soft key (F3) to try again. The 0800 password is a permanent password that can always be used

to unlock the base unit even if a different password has been set.

Note: Because there are no sensors programmed into the EA800 base unit the buzzer will sound when the

timer reaches 00:00 seconds. Press to temporarily silence the buzzer.

You can now access the MAIN MENU programming functions.

Configuring System Parameter Settings

Configuring the system settings consists of selecting date and time display format, setting sensor data collection

frequency, and enabling or disabling the audible alarm. The default system configuration parameter settings are

shown on page 14. To configure the system settings, do the following:

1. Unlock the base unit and access the MAIN MENU.

2. When programming, use the arrow keys, the Enter key , and the three soft keys to advance through the

menus and enter the appropriate information.

0800

Example shown, set values as

appropriate for your system.