Specifications

Use wall thimble

or ceiling firestop

3” (7.5cm)

clearance

Fresh-air

intake

Rain cap

Flashing

3”

6”

(15cm)

6”

Non-combustible

floor protection

Existing floor

(combustible)

36” (91cm)

Tee with

cleanout

1. Choose a stove location that is ideal. See the section Deciding Where to Locate Your Pellet

Appliance.

2. Place a non-combustible hearth pad where necessary.

3. Place the unit on the hearth pad and space it in a manner so when the pellet vent is installed

vertically, it will be 3” (76 mm) away from a combustible wall.

4. Locate the center of the fresh air intake pipe on the unit. Match that center with the same point

on the wall and cut a hole about 1 5/8” (41 mm) in diameter.

5. Install the fresh-air intake pipe.

6. Install the tee with clean out.

7. Install the pellet vent upward from there. When you reach the ceiling make sure that the vent

goes through the ceiling firestop. Maintain a 3” (76 mm) distance to combustibles and keep attic

insulation away from the pipe.

Installation

INSIDE VERTICAL INSTALLATION:

8. Finally, extend the pellet vent to go

through the roof flashing.

9. Ensure that the rain cap is approximately

36” (914 mm) above the roof.

Figure 18