Service manual

41
Troubleshooting
THe sTove will noT sTarT:
Is the stove is plugged in and the wall outlet
is supplying power?
Plug the unit in or fix wall outlet if necessary.
With the stove unplugged, examine all connections. Make sure they
are firmly connected and that there are no exposed wires touching
the stove (except the chassis ground wire). Check the continuity and
placement of connections against the wiring diagrams in this manual.
Are all the connections secure and correct?
NO
Circuit Board Only: Has the control board been
placed in the ON /OFF thermostat mode?
Turn the thermostat up to call for heat.
YES
Timer Control Only (EF2): Unplug the stove. By-pass the start-up switch;
refer to the hoW to’S For trouBleShooting - hoW to By-paSS the Start-up
SWitCh. Plug the stove back in. Does the stove start?
Replace the
start-up switch.
YES
Circuit Board Only: Check the Heat Level
Indicator. Is the # 2 light is flashing?
Refer to “trouBleShooting - light # 2 on
heat output Bar FlaShing.”
YES
Circuit Board Only: Check the fuses on the circuit
board (see “trouBleShooting - CirCuit Board FuSeS”).
Secure all
connections
and correct any
errors.
NO
Is there fuel in the hopper?
Add pellet fuel to hopper.
NO
Has the reset button on the 200°F (93°C)
temperature sensor been tripped?
Unplug the unit and push the red button
to reset the sensor. Ensure the cause is
determined before restarting.
YES
YES
YES
YES
NO
Circuit Board Only: Check the Heat Level
Indicator. Is the # 3 light is flashing?
Refer to “trouBleShooting - light # 3 on
heat output Bar FlaShing.”
YES
NO
NO
Check for the cause of the fuse blowing
before replacing; see “
trouBleShooting -
CirCuit Board FuSeS”
YES