Installation manual

19
HOW TO START AND OPERATE YOUR PELLET APPLIANCE
1. Check and fill hopper with
pellets.
2. Make sure unit is plugged into
a working outlet.
3. Switch the power “ON” by
pushing the start up switch
once only.
4. Turn knob “B” to the 12 o’clock
position. (Lower grade pellets
may need a higher setting on
the feed rate). NOTE: unit will
take longer to light if the
hopper has been completely
emptied.
5. Wait until the fire is
established, then turn knob “B”
to the desired heat output.
(The stove may not be able to
burn in the BLUE ZONE if poor
quality wood pellets are being
used.)
6.
If the stove should shut off
after 15 minutes and there is
still a fire in the firebox – press
the start up switch once more.
If the fire went out, return to
step number 2 and re-light the
stove.
KNOB “A”:
Fan Controller.
By adjusting the knob you will vary the rate of airflow into the room by varying the speed of the convection blower.
When you first start the stove it should be placed in the “OFF” position in order to heat the unit as quickly as
possible. Once the room has come up to temperature the control may be set to a comfortable level.
The flashing green “
Auger Light” corresponds to the timing of the auger turning.
KNOB “B”: Dial a Fire Heat Output Knob. This knob controls the amount of heat output. The dial has a scale
with the blue zone representing the coolest setting of the stove, and the red zone representing the hottest
setting. The scale on knob “B” represents a range, not exact at times or fuel quantities. Wood pellets of differing
quality may effect the performance of the stove. If the stove has trouble operating at either end of its range, turn
the heat output knob back slightly.
TURNING YOUR PELLET STOVE OFF
To turn your stove off, simply turn the HEAT OUTPUT knob (knob “B”) counter-clockwise until the knob clicks to
the “OFF” position. This will stop the feed of pellets. The blowers will continue to run and cool the stove. When
cool enough, the stove will shut down.
Convection
Blower Speed
Control
KNOB A
Auger Light
Start-up
Switch
Dial-A-Fire
Heat Output
Knob
KNOB B